I should know this, but I have searched old posts and still can't find it can someone refresh my memory on the use of these on the lower mounts? looking at the parts books don't help as it's just not clear where they go ??? the B44 and B25 use the same ? TIA for any help Cheers Dennis B
They go on the lower mount, I just fit the engine and use washers to fill the gaps between the engine and the side rails before tightening the stud fasteners, after all these years the gaps are not as they were when they left the factory. The front and rear mounts should need no spacers, if there are large gaps there from worn engine lugs they need repairing, there are steel top hat repair pieces available, its more important for the faces to be good than the hole itself.