Assuming that you have a standard rear rim to lace into-----
I just happen to have a T160 on the lift at the moment so this is what I measured:
a) Offset of approx 1 1/2" from the timing side edge of the rim to the inner edge of the rear brake disc.
Measured with a combination of 6" and 12" steel rules so hence "approx".
b) The longer spokes (7 11/16" are all on the drive side.
c) The shorter spokes (7 7/8" ) are on the timing side.
The spokes with approx 75 degree angle on the outer side and the spokes with the approx 110 degree angle are on the inner side.
d) Photo to follow ref the lacing pattern.