Back at work on Project 39-1/2 ...after ten months (!). Well, you all helped me decide that, Yes, we need a top engine mount. So will this work - its just one set of two Triumph torque stays, two spacers and centrally mounted sturdy bracket welded to frame. There will be a 10mm bolt holding the stays to the frame bracket. This photo is just a set up...
[Linked Image]
If I have to have both sets of torque stays I can do it but it will be a lot more work trying to fit them with all the other frame mounted electrical stuff in that area.
Will this be adequate?
Thanks
Al

Last edited by Al Eckstadt; 06/15/19 12:48 pm.

Al Eckstadt