I'm looking to install a 67-style alternator bracket to a case that has the multi-stepped studs.
Replace this:
[Linked Image]

With this:
[Linked Image]
And this:
[Linked Image]

Is it do-able? It seems that the 67 cases have a bit more surface for the bracket to sit on, but otherwise the parts fit.

Also, why is the stud tapped for two different sizes at one end? Does the bracket take a nut, then the stator sit against that? Why not have the stator nut also hold the bracket in place?

Does anyone have a good picture of this setup?

Thanks in advance