did some work on the timing side cover off the engine today
drawing/designing/fitting of the ugly lump, the axial oil feed to the crankshaft

[Linked Image from 77.163.36.45]

[Linked Image from 77.163.36.45]

[Linked Image from 77.163.36.45]

[Linked Image from 77.163.36.45]


now it has to be welded and drilled to accept the oil-feed
it is not as ugly/protruding as the previous setup but the cover won't fit, pity but then again the modification is obvious.
progress!!
maybe it will be finished this spring


Last edited by lemans; 11/02/19 8:27 pm.